PolySwitch(R) PTC Devices 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 www.circuitprotection.com PRODUCT: AHEF1000 Overcurrent Protection Device Raychem Circuit Protection Products DOCUMENT: SCD 27216 PCN: RF1041 REV LETTER: B REV DATE: JANUARY 22, 2009 PAGE NO.: 1 OF 2 Specification Status: Released Electrical Rating Voltage: Current: 32 VDC MAX 100 A MAX Insulating Material: Cured, Flame Retardant Epoxy Polymer Lead Material: 18 AWG Tin Plated Copper Part Marking: 32 EF10 Manufacturer's Mark and Voltage Part Identification Lot Identification (can be on back) TABLE I. INSTALLATION ENVELOPE DIMENSIONS: mm: in*: A B MIN MAX MIN MAX -23.5 -27.9 -(0.93) -(1.10) *Rounded off approximation C MIN 9.4 (0.37) D MAX 10.9 (0.43) MIN 7.6 (0.30) E MAX --- MIN --- MAX 4.0 (0.16) TABLE II. PERFORMANCE RATINGS: I HOLD RATED CURRENT CURRENT RATINGS INITIAL RESISTANCE VALUES TIME TO TRIP Ra MAX AMPS AT 25C HOLD 10.0 AMPS AT 25C HOLD TRIP 10.0 20.0 OHMS AT 25C MIN MAX 0.0060 0.0105 SECONDS AT 25C, 50 A MAX 15 OHMS AT 25C MAX 0.016 Reference Documents: Precedence: Effectivity: CAUTION: PS400, PS300 (reference for R1 MAX) This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame. Materials Information ROHS Compliant TRIPPEDSTATE POWER DISSIPATION WATTS AT 25C TYP 7.0 ELV Compliant (c) 2008, 2009 Tyco Electronics Corporation. All rights reserved. Tyco Electronics Proprietary Information Pb-Free PolySwitch(R) PTC Devices 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 www.circuitprotection.com Overcurrent Protection Device Raychem Circuit Protection Products PRODUCT: AHEF1000 DOCUMENT: SCD 27216 PCN: RF1041 REV LETTER: B REV DATE: JANUARY 22, 2009 PAGE NO.: 2 OF 2 TABLE III. AUTOMOTIVE SPECIFIC STRESS TESTS AND TEST CONDITIONS: ELECTRICAL STRESS TESTS TEST CONDITIONS (see note 2) ESD Voltage Withstand (see note 1) Short Circuit Fault Current Durability 25kV Fault Current Durability 350 cycles, 32V/100A End-of-life Mode Verification 1750 cycles, 32V/100A Jump Start Endurance (see note 1) Load Dump Endurance (see note 1) 3 cycles, 48V, 2 minute duration 25 cycles, 32V, 200A 10 cycles, 86.5V Note 1: The PolySwitch devices are tested in series with a load resistance and the voltages specified in the test conditions are shared between the PolySwitch device and the load resistance as specified in PS400. Note 2: Please refer to Appendix A of PS400 for the detailed test procedures Tyco Electronics Proprietary Information